Removed the Workplane option from the Nominals tab in the XactMeasure GD&T dialog box.ДЇixed an issue where incorrect conversion happened in the The loss of the diametric zone modifier in some XactMeasure dimensions.ДЇixed an issue where the display of adaptive scan childДЇeatures are seen when you edit in the legacy dimension dialog box. When you edit XactMeasure dimensions in the XactMeasure GD&TДЇixed a migration issue from PC-DMIS version 2012 that caused Line Offsets dialog box when F9 was pressed on the command.ДЇixed the feature highlighting in the Graphic Display window Made improvements to colormap so that it relates better toДЇixed an issue where the selection of the Pointcloud ColormapДid not remember the Use Dimension Color Scale option.ДЇixed an issue where the offset value did not appear in the Graphic Display window were disconnected from the CAD part.ДЇixed an issue where if you switched the Part Model off andДЇixed an issue where PC-DMIS prevented the polar coordinate axis from appearing in the summary label of the Xact Measure position. When there was a part setup transformation. Were not evaluated correctly when they were re-executed.ДЇixed an issue in the Point Nominal Deviation dialog box This isД«ecause you entered the tolerances in two directions.ДЇixed an issue where the Auto Wrist dialog box did not appearДЄnd the CAD transformation matrix had to be a non-identity matrix to enter the failure state.Д¬orrected an issue where, in some cases, laser auto features When you enter a positive a nd negative tolerance in the colormapДialog box, the dimension color scale shows in two directions.The scale shows the colors from 0 to the +Tol value. Tol in the colormap dialog box, the Show colors in two directions option is cleared in the Dimension Color Scale. Two directions option was automatically marked for pointcloud colormaps: Now, Quick Scan with a TTP probe creates a Normal execution mode scan.ДЇixed an issue where the dimension color scale Show colors in

Updated to Release version 2.2 of Edge Client.ДЇixed an issue of Quick Scan where a TTP probe created aДefined scan. Were not set properly before computation of the colormap annotation When you clear the Always visible check box, the Point Colormap points and text only appear if they appear in the current view.ДЇixed an issue for Pointcloud Colormaps where the tolerances

Or hid the points and text based on whether you marked theДЄlways visible check box on the OpenGL tab in the

Linear Closed scan path if there were holes in the path.ДЇixed an issue that incorrectly removed feature labels from aДЇixed an issue where the Pointcloud Point Colormap showed Maybe some problems on install, look here :ДЇixed an issue where PC-DMIS was not able to generate a

Pc dmis 2018 r2 spc 6